During a holiday (and being there for other reasons) in Denmark I have made an update to the "Thor's Hammer" QRSS grabber. More will happen later at another visit.
The grabber can, as usual be found at :
The grabber now works on two bands, a more stable receiver (old TRX with defective TX) has been installed for 10 MHz and the viewable frequency range reduced. Still using an older low powered PC
10 MHz Grabber :
RX range : 10139.880 - 10140.120 kHz
SpectrumLab set for display of 3 stripes of consecutive periods
Antenna : indoor dipole
500kHz Grabber :
RX range : 502.700 - 505.500 kHz - some noticeable frequency drift, but acceptable
SpectrumLab set for 3 strips as above
Antenna : indoor multi turn tuned loop
The 500kHz RX seems to have some problems with receiving WSPR, only once or twice the WSPR signals from PA0A and PA0O have been received.
The signal from (I think) G3XIZ was visible, but no decodes.
All in all I am fine with the improvements, but more is needed. I would like to add more bands, e.g 80m, 40 and 20m, possibly 136kHz but things do take time to get running, and new antennas will be necessary.
I may experiment with a wide band active loop antenna (H-probe) or an E-probe (short active whip).
More "Canned Seafood" Homebrew CW, from KA4IBG - Bill: My xYL hates sardines, but they look good together ! In the late 70's the community had a fetish for canned seafood and DC receivers. Do you remember...
22 hours ago